$0.00
View All
DuraChimney II pipe is available in 12", 18", 36", and 48" lengths. To calculate the installed length of DuraChimney II pipe, subtract 1" from each length of chimney pipe. DuraChimney II is built to order and is not returnable.
DuraChimney is a double-wall, air-cooled chimney system for use with masonry fireplaces which burn wood, oil, coal or gas. DuraChimney is an exceptional factory-built alternative to pre-fabricated masonry chimneys that provides a hot draft on the insude and proves a fire-safe design that protects both the chimney and the building.
Item#: 2591914
x
Item#: 2591919
Item#: 2591924
Item#: 2591929
Use elbows to offset obstructions such as rafters, ridgepoles, or joists. 10"-16" DuraChimney II may have one pair of elbows, if needed. Offsets greater than 30° are not allowed. Elbows are not adjustable.
Item#: 2591934
Item#: 2591939
Use between two elbows to support the weight of the chimney.
Item#: 2591944
Use to help support weight of DuraChimney II. Supports a maximum of 25' of chimney. Use additional Supplementary Supports as needed.
Item#: 2591949
Use to hold DuraChimney II in place. Use inside chase enclosures to stabilize chimney installation. Refer to fireplace manufacturer for additional requirements on use of Stabilizer.
Item#: 2591954
Use as a starter section for DuraChimney II. Bolts directly to fireplace outlet.
Item#: 2591959
Use as a starter section for DuraChimney II. Bolts directly to fireplace outlet. Damper section allows chimney to be closed when fireplace is not in use. Includes chain and lintel hook.
Item#: 2591964
Use in ceiling/floor penetrations above fireplace. Firestop is not required when passing through the roof. Fits on underside of ceiling.
Item#: 2591969
Use in all installations that pass through an attic to prevent insulation and debris from accumulating near the chimney, unless chimney is enclosed through attic. Consists of two parts, collar and base.
Item#: 2591974
Required at top of chase enclosure or where chimney passes through the roof. Roof Radiation Shield is not required if chimney is unenclosed in the attic. Four plates (included) make up one shield. Three of the four plates are shown.
Item#: 2591979
Encloses the top of a chase while providing a ventilation air passage to the chase. Includes spacer clips.
Item#: 2591984
Use to construct custom sized chase tops. Provides necessary ventilation and spacing to maintain UL listing for chimney system.
Item#: 2591989
Use to terminate chimney system. Required on all installations. Slides over previous section of DuraChimney II pipe to allow for chimney height adjustment. Shown with optional Spark Arrestor screen.
Item#: 2591994
Use on inside of cap. Optional Spark Arrestor may be required.
Item#: 2591999
Use to prevent rain from entering chase. Use with a flashing and chimney cap.
Item#: 2592002
Use to support and to stabilize the chimney in interior or exterior installations to ensure a 2" clearance. Wall Straps are required every 8' on exterior of building only.
Item#: 2592007
Use for installing the European Copper Chimney Pots King model shroud/pot onto DuraChimney II chimney.
Item#: 2592012
Use for installing the European Copper Chimney Pots Bishop model shroud/pot onto DuraChimney II chimney. King model shown.
Item#: 2592016
Item #:
This Item Ships FREE!
$0.00
