Use to support and to stabilize the chimney in interior or exterior installations to ensure a 2" clearance. Wall Straps are required every 8' on exterior of building only.
DuraChimney is a double-wall, air-cooled chimney system for use with masonry fireplaces which burn wood, oil, coal or gas. DuraChimney is an exceptional factory-built alternative to pre-fabricated masonry chimneys that provides a hot draft on the insude and proves a fire-safe design that protects both the chimney and the building.
Use to construct custom sized chase tops. Provides necessary ventilation and spacing to maintain UL listing for chimney system.
Use to help support weight of DuraChimney II. Supports a maximum of 25' of chimney. Use additional Supplementary Supports as needed.
Use to prevent rain from entering chase. Use with a flashing and chimney cap.
Use to hold DuraChimney II in place. Use inside chase enclosures to stabilize chimney installation. Refer to fireplace manufacturer for additional requirements on use of Stabilizer.
Use on inside of cap. Optional Spark Arrestor may be required.
Required at top of chase enclosure or where chimney passes through the roof. Roof Radiation Shield is not required if chimney is unenclosed in the attic. Four plates (included) make up one shield. Three of the four plates are shown.
DuraChimney II pipe is available in 12", 18", 36", and 48" lengths. To calculate the installed length of DuraChimney II pipe, subtract 1" from each length of chimney pipe. DuraChimney II is built to order and is not returnable.
Use in ceiling/floor penetrations above fireplace. Firestop is not required when passing through the roof. Fits on underside of ceiling.
Use for installing the European Copper Chimney Pots King model shroud/pot onto DuraChimney II chimney.
Use for installing the European Copper Chimney Pots Bishop model shroud/pot onto DuraChimney II chimney. King model shown.
Use between two elbows to support the weight of the chimney.
Use to terminate chimney system. Required on all installations. Slides over previous section of DuraChimney II pipe to allow for chimney height adjustment. Shown with optional Spark Arrestor screen.
Encloses the top of a chase while providing a ventilation air passage to the chase. Includes spacer clips.
Use in all installations that pass through an attic to prevent insulation and debris from accumulating near the chimney, unless chimney is enclosed through attic. Consists of two parts, collar and base.
Use as a starter section for DuraChimney II. Bolts directly to fireplace outlet. Damper section allows chimney to be closed when fireplace is not in use. Includes chain and lintel hook.
Use as a starter section for DuraChimney II. Bolts directly to fireplace outlet.
Use elbows to offset obstructions such as rafters, ridgepoles, or joists. When installing 10"-16" DuraChimney II you may install a pair of elbows if needed (sold as individuals). Offsets greater than 30º; are not allowed. Elbows are not adjustable.
DuraChimney is a double-wall, air-cooled chimney system for use with masonry fireplaces which burn wood, oil, coal or gas. DuraChimney is an exceptional factory-built alternative to pre-fabricated masonry chimneys that provides a hot draft on the inside and proves a fire-safe design that protects both the chimney and the building.
Use elbows to offset obstructions such as rafters, ridgepoles, or joists. 10"-16" DuraChimney II may have one pair of elbows, if needed. Offsets greater than 30° are not allowed. Elbows are not adjustable.
This Item Ships FREE!