http://www.woodlanddirect.com/Outdoor/Pumps/SuperFlo-2000-Pond-Pump Ceramic shaft 4 fountain heads Use with 200-400 gallons 500 GPH Black 12" 1" outlet 12" telescopic riser Yes Fountain heads, pre-filter, telescopic riser, and diverter Variable flow-rate adjustment knob |Vibration-damping rubber pads that allow it to run in absolute silence |Fountain spray adds oxygen to your pond. Excellent for aeration and water circulation
SuperFlo 2000 Pond Pump
Item#: 2360016
Overview
 
Specs
 
Warranty

The SuperFlo 2000 Pond Pump is great for ponds sizes 200-400 gallons. This is an all-in-one kit with everything you need to create beautiful water features in your pond. This energy efficient, submersible, magnetic-driven pump can accommodate a stream, small waterfall and create a fountain! This Superflo pump features four fountain heads, a flow diverter, telescopic rise, coupling, mechanical filter and tubing outlet. You can now add one or two extra filters to your pond kit to extend the life of your pump!

The motor is a permanent magnet-driven synchronous motor. The earth-magnets in this motor are made from alloys of rare earth elements, which are substantially stronger than the ferrite magnets which inexpensive pumps utilize. The pump also has water resistent ceramic shaft and brushes. The flow-rate can vary with the adjustable knob and this pump runs in silence with it's vibration-damping rubber pads. Because this pump has a fountain spray oxygen is added to the pond which is excellent for aeration and water circulation.

Maintenance: The SuperFlo 2000/3000/4000 Pumps are cetrifugal pumps with a magnetic movement, driven by a watertight synchronous motor. They require minimum maintenance, only periodic cleaning of the filtering material and the rotor. Remember, before doing any work on your pump you MUST turn it off! To clean the filtering material, simply remove the filter and rinse the sponge.To clean the rotor, after having removed the filter, release the cover B by turning it counter-clockwise and take out the rotor. Wash everything in lukewarm water, using a soft brush to remove any deposits of scale. Then reassemble the parts. Attention! The ceramic shaft on which the rotor turns may be removed for cleaning, as it is secured at the two ends by two rubber red caps. As with the other parts, wash in lukewarm water using a soft brush to remove scale build up.


 



  |   Ships Within: