Spark Guard Curtains

This quality Spark Screen Curtain and Rod Kit is designed to be installed into almost any fireplace. The Rod Assembly (sold separately) consists of two 3/16"; metal rods that are 32"; long. The rods attach to the side of the fireplace opening and are supported in the middle by a mounting bracket. The total width of the rod assembly can extend to 58".

Sizing: Select the height of the screen that is approximately 1-2"; less than your fireplace opening. This will compensate for the installation of the rod and will keep the screen from dragging on the ground.

Installation Instructions

If you are looking for a replacement set of rods for your fireplace spark screen you will be happy with this rod kit.
The Fireplace Spark Screen Rod Kit safely extends to a length of 58 inches. This rod kit is also easy to install and secure with a mounting screw. One end of each rod is flattened and has a 1/4" hole prepunched for mounting. The kit also has a steel mounting bracket with offset punch tabs to hold the other end. The bracket is designed for the mesh panels to cleanly pass by each other when it is fully closed. The center bracket has an adjustable mounting bracket which will allow you to mount it either on the top or from the front.

You can order a couple of these rod sets today and you can quickly and easily attach your spark screen and have an extra set on hand just in case you may need another one in the future.

Reduce heat and energy loss with this Fireplace Blocker, an exclusive with Woodland Direct! Place this fireproof blanket over the outside of your fireplace screen when only embers are burning, leaving the flue open, to keep the heat inside your house-rather than sending the heat and your money up your chimney. Made of non-woven carbon fiber it secures to your screen with magnets to "keep the heat" in your home!

This product is intended to be used to reduce heat and energy loss through a fireplace with an open flue until the flue can be safely closed. This product should never be placed inside the opening to the fireplace, used with a closed fireplace flue, or used with a fireplace containing flames. This product should be attached to the outside of a fireplace screen once only embers remain in the fireplace, and the fireplace flue must remain open at all times while this product is in use. This product should not be used to extinguish a fire and should not be placed near a fireplace containing flames. This product is designed to be an energy saving device and is not designed or intended for use as a fire containment device.